Basco 7150-44TCLOR Installation Guide download pdf (Page 7)

BASCO

TOWEL BAR

ASSEMBLY

FINGER

PULL

7/8” TRUSS

HEAD SCREW

1 1/8” FLAT

HEAD SCREW

DECAL

TUB

TRACK

GLAZED

PANELS

CENTER

GUIDE

INTERIOR

#6 X 3/8 “ PAN

HEAD SCREW

BUMPER

WALL

JAMB

SCREW &

SPACER

INSERT

WALL SIDE

OF PANEL

10 From the exterior, insert a #10-24 x 7/8”

truss head screw [N] through the rail that is closest

to the center of the opening of the interior panel.

Then, insert a #10-24 x 1 1/8” flat head screw [P]

through an acrylic finger pull [R] and then through

the rail that is closest to the wall. Attach a towel bar

assembly, with the open slot in the bar facing down,

to the interior panel by threading the screws into the

acrylic brackets. (CAREFUL as to not overtighten

the screws and strip the acrylic). Peel the backing

from a BASCO decal [S] and press it into the recess

of the acrylic finger pull.

Repeat the above steps, but from the interior, for the exterior panel.

11 Locate the nylon bottom guide [T] in the

middle of the bottom track with both door panels

against the wall with the shower head. Using a 1/8”

drill bit, drill a hole into the “V” groove of the bottom

track through the hole in the nylon guide.

Install the guide using a #6 x 3/8” pan head screw [U].

12 Align the slots in the soft jamb bumpers [W]

with the outer rails of the door panels (the side rails

with the acrylic finger pulls). Slide the stainless steel

bumper inserts [V] into the soft jamb bumpers with the

open slot facing downward.

Slide the bumpers downward over the center wall jamb

screw until they “lock” onto the nylon spacers installed

in Step #4.

QCI0023 Rev. 1 Page 7 of 8 Certified 8/20/10

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Basco 7150-44TCLOR Installation Guide Page 7

Comments to this Manuals